Monthly Archives: June 2012

So the car made it to it’s MOT, it was good to take it for a drive (even if the MOT garage was only a mile or two away) Apologies for the low image quality, it’s a phone camera, and … Continue reading →

Unfortunately this needed the same treatment as the passenger side. It was quicker to do though. More fettling required as it’s not level with the passenger side. I suspect the passenger side to be at fault though.

The rest of the Thursday evening saw work start on the dash. Here it is again in it’s original state: First job was to cut the hole for the steering column. Fairly easy with a 22mm (I think, might be … Continue reading →

Rather than drill holes in the inner face of the grill area I followed what most people do and siliconed cable tie mounts inside. The cable ties would then secure the grill and be out of view. That passenger cycle … Continue reading →

I’d previously drilled the cycle wing stays and marked the positions on the cycle wings. I then siliconed big head bolts in place. I then fibreglassed over the top to hold them in. In hindsight this was wrong. The silicone … Continue reading →