Category Archives: Build

Rather than drill holes in the inner face of the grill area I followed what most people do and siliconed cable tie mounts inside. The cable ties would then secure the grill and be out of view. That passenger cycle … Continue reading →

I’d previously drilled the cycle wing stays and marked the positions on the cycle wings. I then siliconed big head bolts in place. I then fibreglassed over the top to hold them in. In hindsight this was wrong. The silicone … Continue reading →

I finally got around to investigating why the wipers weren’t working. It seemed the motor was getting 12v at the earth feed and this was going through and out of the inputs. This is because in the Mazda SDV build … Continue reading →

Over the next couple of days I concentrated on fitting the interior. I’d tried to hold this off until the end but I got carried away. It was just the dash fitting left that would get the interior dirty anyway. … Continue reading →

These seem to be relatively easy to get level with the FW bodywork – not sure how it is with the standard nose cone. There’s a feature line extending almost to the front of the car. You take a measurement … Continue reading →